process
Our process.
Every job moves through the same four steps on our floor: cut, fabricate, finish and deliver. Scroll through them, then take a closer look at what comes out the other end.
From plate to pit.
Plate goes on the table.
Mild steel and wear plate are profiled on our CNC plasma and oxy-fuel table, from your drawing or ours.
built here
Cut, welded and painted in Bekasi.
Every bucket on this page left our floor. Tell us the machine and the job, and we'll build it to fit: pins, width, teeth and all.
- 1Mounting ears. Pin bosses bored to your machine's pin size and spacing.
- 2Shell and side plates. Rolled shell with welded side plates, sized to the bucket width you need.
- 3Teeth and adapters. Bolt-on teeth and adapters that can be swapped on site.
- 4Cutting edge. Wear plate along the lip, where the bucket takes the abuse.
in 3D
Turn it over.
Drag to spin a finished bucket from our floor. Zoom in on the teeth, the side plates and the mounting ears.
3D model generated from a photo of the finished bucket. The proportions are close; it is not a CAD drawing.
Loading 3D model…
Tell us what you need built.
Put your request together in a minute and send it straight to WhatsApp.